Feeder is often used in electrical hardware accessories, computer hardware accessories, mobile phones hardware accessories, digital products hardware accessories before stamping leveling work, only by leveling, can produce qualified five parts, so the feeder is indispensable to the production of stamping production equipment, the whole even some beyond the scope of the plate material, although a short period of time is no problem, but a long time light can cause roller bearing damage, can cause roller or motor damage, caused to halt or delay of production, if the bearing damage as long as in the following steps, can own in a timely manner to solve, which does not affect the production schedule:
1. Firstly, disconnect the power supply machine, and then fold the screw down with the inner hexagon wrench with the inner hexagon wrench to lower the guard plate to the side.
2. Remove the screw from the top of the motor to the machine head.
3, if the leveling roller bearing was not damaged, the damage of leveling roller bearing on this as long as the replacement are reassembled in good is ok, if the leveling roller bearing is damaged is to complete the following steps under the roller leveling off replacement.
4. Fold the dial indicator and adjusting screw on the feeding machine head, and then remove the upper plate.
5. Open the side panel of the feeder with the inner hexagon wrench.
6. Then loosen the four screws of the fixed motor and fold the transmission chain down.
7. Move the feeding machine head to the forklift and remove the screw from the bottom of the roller.
8. The upper part of the plate can be removed and the upper part of the feeder can be lifted out.
9. Then we can take out the whole of the feeder roller group and replace the damaged roller bearing.
10. After replacing the bearings, you can assemble them in order, and then spread the butter on the gears and install the guard plate.
No comments:
Post a Comment